DINITROL® 440 grau
DINITROL® 445 schwarz
Dröhnex Bodywork Protection
Characteristics:
DINITROL 440 and DINITROL 445 are long-term protection products against corrosion and stone
chipping with a synthetic resin/plastic basis. After drying, the materials are resistant to carbon
hydride-based cold cleaning agents, surfactant-based acid and alkaline high pressure cleaners,
salt water and road salt.
Application:
The products are especially suitable for coating entry steps, door sills, spoilers, rear valances and
wheel housing, and in light of its anti-drone effect, for interior spaces, boots, bonnets, etc. where
bitumen-based products cannot be used.
Other areas of application are the rear coating on cladding to reduce rattling noise caused by hail
or rain, or the machine cladding coating.
Method of Use:
The surface to be treated must be clean and free from dust and grease. Loose rust must be removed.
Concerning corrosion pits from which rust cannot be removed using a brush, we recommend
pre-treatment with rust converter. Smooth lacquers should be burnished before coating.
DINITROL 440 and DINITROL 445 are supplied in a ready-to-use condition.
To apply the product, a suction pipe gun with an approx. 3 mm nozzle is screwed onto the funnel
bottle and the product is sprayed evenly onto the dust and grease-free surface with air pressure
of 3 - 5 bar. Layer thicknesses of up to 1 mm can be applied wet per application procedure.
After material application, the gun must be cleaned carefully, given that blocked guns may cause
the can to explode. If the material is not yet dry, spray mist and spatters can be removed with a
cloth soaked in petroleum spirit.
Dried material can be removed with nitro thinner or through mechanical filing. If necessary, the
products can be coated with standard vehicle lacquer after drying.
The material must be completely dry before applying lacquer.
Technical data:
Colour: Black Grey
Base: Synthetic resin / plastic Synthetic resin / plastic
Solvent: Ester / aromatic solvents Ester / aromatic solvents
Solids content: ~ 58% ~ 58%
Density: 1.28 g/cm³ 1.17 g/cm³
Flash point: 4°C 4°C
Processing temperature: 15°C -25°C 15°C -25°C
Package size: 1 litre 1 litre
Yield p. m² / 0.5mm: Approx. 700 g Approx. 700 g
Salt spray test: 500 µm dry film 500 h 500 µm dry film 500 h
Koop nu per stuk
Koop nu per 10 stuks